Features and Applications:

1. To be applied on interior walls and floors or on exterior floors.
2. Suitable for ceramic tiles with a medium-high absorption rate.
3. No need to wet tiles or substrates thanks to its high water-retaining capacity.
4. Non slip. Excellent initial adherence.
5. Long open time. Allows rectification.
6. Resistant to humidity. Swimming pool tiling.
7. Indoor cladding on gypsum-carton sandwich panels.

Substrates

1. Conventional cement-based substrates.
2. Indoor ceramic cladding and flooring.
3. Substrates must be resistant, stable, sound and clean, free of dust, demolding agents, organic products, etc.
4. All substrates must have the appropriate flatness. Otherwise, smooth down up to 5 mm with the same product 48 hours prior to bonding. For greater thickness, use traditional dry mortars or levelling paste.
5. In case of hot or windy weather conditions or when applying over absorbent substrates, it is advisable to wet the substrate and wait till the thin layer of water disappears.
6. Do not apply on clay or on paint.
7. On outdoor flooring, substrates must have a gradient equal or superior to 1%.

Instructions for use

1. Add water and mix by hand or mechanically until it takes on an even and workable consistency.
2. Let the mixture stand for 5 minutes and remix.
3. Spread the mixed product on the substrate with a trowel to a maximum surface area of 2m2.
4. Spread with a notched trowel to adjust thickness (see chart).
5. Lay the tiles, press and make small rotation movements to ensure that the glue gets in total contact with both surfaces.
6. Observe construction joints (expansion, contraction, fraction, perimeter corner joints) and the joints between the cement slabs (minimum 2mm).
7. Joints should be grouted 24 hours after if on vertical surfaces, and 48 hours after if on floorings. Use either MORCEM LECHADA OR MORCEMCOLOR depending on the type of joint.

NOTE: For better results lay tiles as soon as possible after spreading.

Cautions and recommendations

1. Do not apply below 5ºC nor above 30ºC.
2. Do not apply when there is a risk of frost, rain, strong wind or direct sunlight.
3. Under extreme weather conditions (gusty winds or high temperatures) drying may occur faster.
4. On floor areas larger than 30 m2, leave partition joints to be filled with a flexible material.
5. On interior floorings larger than 15 m2, it is advisable to keep a free perimeter expansion joint between the floor and the wall or pillar, hidden by a baseboard.
6. Check that the gypsum board is firmly fixed before applying on it.
7. For gypsum based substrates, use PEGOLAND - GYPSUM, avoiding slaked or poor plaster.
8. The watertightness of the swimmingpool must be guaranteed by the underlying concrete structure.

Packaging

25 kg plastic-lined paper bags
Shelf life: 1 year in sealed original packaging, sheltered from weather conditions and humidity.

Note

Instructions of use are given based on our testing and knowledge and do not imply any commitment. Said instructions do not free the user from examining and verifying the product for its correct use.

The manufacturer's liability is limited to the value of the used goods.